primary winding
英 [ˈpraɪməri ˈwɪndɪŋ]
美 [ˈpraɪmeri ˈwɪndɪŋ]
一次绕组；原绕组
英英释义
noun
- coil forming the part of an electrical circuit such that changing current in it induces a current in a neighboring circuit
- current through the primary coil induces current in the secondary coil
双语例句
- And finally, on the basis of the magnetic integration, the application of passive integration technology, through staggered parallel structure in the primary winding of transformer in the integrated resonant capacitor, through the Maxwell 2D simulation software to validate the correctness of the design.
最后，在平面磁集成结构的基础上，应用无源集成技术，通过交错并联结构在变压器原边中集成谐振电容，并通过Maxwell2D仿真软件验证设计的正确性。 - The influence between Section spacing of secondary winding, primary winding and flux leakage of magnetic core to the secondary winding are simulated, the equivalent factor is introduced between the rectangular wire and the round wire.
模拟分析次级绕组段间距、初级绕组以及磁芯漏磁对次级绕组损耗的影响，并引入了矩形导线和圆导线之间的等效因子。 - Through various short-circuit current temperature rise test results, the transformer temperature, time, and a high degree of three curves, obtained directly within the thermal region transformer primary winding height of about 83.3%.
通过在不同短路电流条件下的温升试验，得到了变压器内部的温度与时间、纵向高度之间的关系曲线，得出变压器内部热区域主要集中在约绕组自下而上高度的83.3%区域。 - The distribution of the third harmonic magnetic field in imported large rectifier transformer is analyzed. The reason of conductor damage in winding is discussed. The overheat possibility in primary winding is expounded.
分析了进口大型整流变压器三次谐波磁场的分布，讨论了绕组导体绝缘损坏的原因，一次绕组存在过热的可能性，提出了可采取的改进措施。 - Rising Current Method at CT Primary Winding and Its Application
电流互感器一次升流的方法与应用 - The transformer adopts multiple secondary compensation winding structure. The primary winding is in parallel with the harmonic load and the secondary compensation windings are connected with PWM inverters.
变压器采用副方多补偿绕组结构，原方绕组与谐波负载相并联，副方补偿绕组分别与逆变器相联。 - Giving out the method for calculating and selecting fundamental performance parameters, such as primary current, primary winding, secondary current, secondary load, time constant and so on.
给出了TA的主要参数，如一次电流、一次绕组、二次电流、二次负荷、时间常数等的选择和计算方法。 - A new way to measure the conducted electromagnetic interference, which regards the IGBT of injected port of primary winding in automobile port fire as a power supply working in switch model, has been provided.
提出了一种把汽车点火系统的初级线圈电压注入端的绝缘闸双极性晶体管（IGBT）作为一种开关模式电源并对其工作时产生的传导干扰进行测量。 - The High Tension ( HT) voltage is produced by mutual induction between the primary winding and the secondary winding, and the central soft iron core intensifies the magnetic field between them.
通过初级绕组和次级绕组之间的互感产生出一个高电压，把两绕组联系起来的中心软体起导磁的作用，它把磁场集中起来。 - The unbalanced degrees of current in primary winding under different load conditions are discussed, which are based on the general expressions of negative phase sequence current.
结合负序电流的通用表达式，讨论了在不同负荷条件下的原边电流不平衡度。